reefnomad reefnomad

Today at 12:23 PM
Mathematics

Answered

What two numbers multiplied equal 48 and when added together equal -13

Answer :

AngelicSmite AngelicSmite

Today at 12:28 PM

-5 and -8
-5•-8= 48
-5+-8=-13

Answer Link

Other Questions

If you purchase a house worth $125,000 and make a 10% down payment, how much would one mortgage point cost at closing? 1)$765 2)$995 3)$1,125 4)$1,535 5)$1,800

A weight suspended from a spring is seen to bob up and down over a distance of 14cm twice each second. A) What is the frequency?B) What is it's period?C) What i

If you purchase a house worth $125,000 and make a 10% down payment, how much would one mortgage point cost at closing? 1)$765 2)$995 3)$1,125 4)$1,535 5)$1,800

Describe one way gardening might make someone aware of the natural world and of using resources in a sustainable way

Determine the 4-day sma for the ten consecutive day closing prices for wal-mart stores inc. listed below. $57.35, $58.61, $57.98, $58.07, $57.50, $56.97, $56.35

Conditions when transpiration is minimum

The selling price of 10 areticle so is the same as the cost price of 11 articles.find the gain percent.

a)The narrator's elbow went clear through

pls answer my question

What is (h+) of a solution that is 0.1 m hcn and 0.2m nacn?

What is the purpose of the needs analysis phase in the system life cycle?

You are designing a machine component that experiences rotating-bending cyclic loading during its life cycle. An example would be a gear shaft with one or multi

For the cantilever reinforced concrete beam, determine the maximum moment product of the distributed load. From this, check if the rectangular cross section of

A 1040 steel is quenched and then tempered at 500degC. The cooling rate from the quenching temperature must be controlled because otherwise .

Column Buckling: Given a circular solid column carrying a compressive load of 8500 lb with pinned ends. The length is 50 in. Use SAE 1020 HR steel and a design

Estimate the machining time in face milling given the following data: Cutter: 20 teeth and 100 mm in diameter Rotational speed: 300 rpm Depth of cut: ?

Components subjected to large contact forces (e.g., brake disks) are often made of high-grade steel coated with a thin film of a very hard material, such as dia

Determine the angular displacement of the LHS gear as the crank rotates 20 degrees clockwise by using the geometric analysis.

An individual's chances of getting lung cancer from radon depend mostly on? 1) the level of radon in a person's building 2) the amount of time spent in a person

What is the main purpose of the House of Quality for a smart flood barriers control?